Revised Spec trx 2.0

Trx 850 frame with rear side tubing removed. FCR41's with open bell mouths, single cable throttle, r6 1999 radiator fan removed, Full bore race exhaust from projection components. R1 aluminium front fairing frame, Modified R1 yokes with trx stem( projection components ), complete R1 front end. Nitron 3 way race shock, yzr750 rear end. Renthal 520 chain conversion race sprockets from Thundercat Modified cheapo 'Rear sets' lightweight from Thailand! Crankcase breather tube from generator and cylinder head to enclosed container under tank with filter. Modified R 7 fairing. A 2000 cbr6 glass fibre race seat. P&R racing GPS laptimer. Wiring loom kept original apart from the safety start soleniod removed....
Rear rain light fitted. clocks modified, just using Rev counter.

Weight TBA!

Saturday, 30 March 2013

First fire up

First fire up, connected a quick release fuel line connector for ease of maintenance, highly recommended as they don't leak, self cut off  etc. fidgeted the vacuum hoses on. Let the starter run without leads on so oil is pumped around as its been sitting for months without oil.
Connected plugs and leads. Squirted ether down the funnels and thumbed the starter. Took a 30 seconds of squirting but this would make the engine fire up in spits and starts helping the fuel pump prime the carb...at the time of running, the ignition was on full advance, sounded terrifyingly loud once running...!...thumbs up to Projection components!
Posted by at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)