Revised Spec trx 2.0
Trx 850 frame with rear side tubing removed. FCR41's with open bell mouths, single cable throttle, r6 1999 radiator fan removed, Full bore race exhaust from projection components. R1 aluminium front fairing frame, Modified R1 yokes with trx stem( projection components ), complete R1 front end. Nitron 3 way race shock, yzr750 rear end. Renthal 520 chain conversion race sprockets from Thundercat Modified cheapo 'Rear sets' lightweight from Thailand! Crankcase breather tube from generator and cylinder head to enclosed container under tank with filter. Modified R 7 fairing. A 2000 cbr6 glass fibre race seat. P&R racing GPS laptimer. Wiring loom kept original apart from the safety start soleniod removed....
Rear rain light fitted. clocks modified, just using Rev counter.
Weight TBA!
Subscribe to:
Post Comments (Atom)
What seat unit did u use? Did u cut the frame?
ReplyDeleteWhat seat unit did u use? Did u cut the frame?
ReplyDeleteIt's a cbr600 2000 fibreglass race seat unit. I removed the thin steel tubing just along from where the rear pegs go. This is the second frame , if you look back at the older posts you will see I cut more off and created my own aluminium attachment which bolted on to a small weeded section. This frame was bent in a crash so it was cheaper to get another than pay for Motoliner to straighten it.
ReplyDelete