Revised Spec trx 2.0

Trx 850 frame with rear side tubing removed. FCR41's with open bell mouths, single cable throttle, r6 1999 radiator fan removed, Full bore race exhaust from projection components. R1 aluminium front fairing frame, Modified R1 yokes with trx stem( projection components ), complete R1 front end. Nitron 3 way race shock, yzr750 rear end. Renthal 520 chain conversion race sprockets from Thundercat Modified cheapo 'Rear sets' lightweight from Thailand! Crankcase breather tube from generator and cylinder head to enclosed container under tank with filter. Modified R 7 fairing. A 2000 cbr6 glass fibre race seat. P&R racing GPS laptimer. Wiring loom kept original apart from the safety start soleniod removed....
Rear rain light fitted. clocks modified, just using Rev counter.

Weight TBA!

Sunday, 17 February 2013

Rebuild

Managed to get 30mins in the garage, the frame is all painted, laquered. Started of by fitting the the bottom yoke and top, making sure plenty of grease squashed in around the tapered bearings.
Just got to just open out about 4mm about 0.5 mm on the top hat spacer because the bottom thread of the stem goes into it and fouls it. The large secondary spacer I have goes above the top yoke, I did think of putting it below but that would mean the forks would be too high.


Posted by at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)